Bandwidth Control; Control Settings - TP-Link TL-WR810N User Manual


Destination Network - The Destination IP Address is the address of the network or host to
which the static route is assigned.

Subnet Mask - The Subnet Mask determines which portion of an IP address is the network
portion, and which portion is the host portion.

Gateway - This is the IP address of the gateway device that allows for contact between the
Router and the network or host.

Interface - This interface tells you whether the Destination IP Address is on the LAN &
WLAN (internal wired and wireless networks), the WAN (Internet).
Click the Refresh button to refresh the data displayed.

4.15 Bandwidth Control

Figure 4-72 The Bandwidth Control menu
There are two submenus under the Bandwidth Control menu as shown in Figure 4-72. Click any
of them, and you will be able to configure the corresponding function. The detailed explanations
for each submenu are provided below.

4.15.1 Control Settings

Choose menu "Bandwidth Control → Control Settings", you can configure the Egress
Bandwidth and Ingress Bandwidth in the next screen. Their values you configure should be less
than 100000Kbps. For optimal control of the bandwidth, please select the right Line Type and ask
your ISP for the total bandwidth of the egress and ingress.

Enable Bandwidth Control - Check this box so that the Bandwidth Control settings can take
effect.

Line Type - Select the right type for you network connection. If you don't know how to choose,
please ask your ISP for the information.
TL-WR810N
Figure 4-73 Bandwidth Control Settings
- 86 -
300Mbps Wireless N Mini Router