Bandwidth Control - TP-Link TL-WR940N User Manual

Chapter 4
• Destination Network
to which the static route is assigned.
• Subnet Mask - The Subnet Mask determines which portion of an IP address is the
network portion, and which portion is the host portion.
• Gateway - This is the IP address of the gateway device that allows for contact between
the Router and the network or host.
• Interface - This interface tells you whether the Destination IP Address is on the LAN &
WLAN (internal wired and wireless networks), or the WAN(Internet).
• Click Refresh to refresh the data displayed.

4. 11. Bandwidth Control

4. 11. 1. Control Settings
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to Bandwidth Control
The values you configure for the Egress Bandwidth and Ingress Bandwidth should be
less than 100,000Kbps. For optimal control of the bandwidth, please select the right
Line Type and consult your ISP for the total egress and ingress bandwidth.
• Enable Bandwidth Control
can take effect.
- The Destination Network is the address of the network or host
> Control Settings.
- Check this box so that the Bandwidth Control settings
Configure
50