TP-Link TL-WR810N User Manual page 30


Note:
Auto-Detect function is not suitable for L2TP/Russia L2TP and PPTP/Russia PPTP, you need to
specify the connection type manually.
If you select Auto-Detect, the Router will automatically detect the connection type your ISP
provides. Make sure the cable is securely plugged into the WAN port before detection. The
appropriate configuration page will be displayed when an active Internet service is successfully
detected by the Router. Then follow the instructions to complete the configuration.
1) If you select Dynamic IP manually, the next screen will appear as shown in Figure 3-7.

In most cases you don't need to clone the MAC address if you have rebooted the
modem with the new router, please select No, I do NOT need to clone MAC
address.

If you can't get the Internet connection after Quick Setup, please run it again and
select YES, I need to clone MAC address.
Then click Next and Figure 3-12 will appear.
2) If you select Static IP manually, the next screen will appear as shown in Figure 3-8. This
type of connection uses a permanent, fixed (static) IP address that your ISP assigned. In
this type, you should fill in the IP Address, Subnet Mask, Default Gateway, and DNS IP
address manually, which are specified by your ISP. Then click Next and proceed to Figure
3-12.
3) If you select PPPoE/Russia PPPoE manually, the next screen will appear as shown in
TL-WR810N
Figure 3-7 Quick Setup - MAC Clone
Figure 3-8 Quick Setup - Static IP
- 14 -
300Mbps Wireless N Mini Router