Repair And Maintenance; Adjusting Brakes - Razor Pocket Mod Owner's Manual

REPAIR AND MAINTENANCE

Turn power "OFF" before conducting any maintenance procedures.
q Adjusting Brakes
1
Thread brake lever adjuster in
or out 1/4 to 1/2 turn until desired
brake adjustment is attained. If
brake still needs further
adjustment, proceed to step 2.
q Chain and Rear Tire Replacement
1
Remove screws that secure
chain guard and remove chain
guard.
4
Loosen axle. Slide wheel
forward to loosen the chain.
7
Tighten brake housing
anchor securely.
2
If brake is too tight or has too
much slack, loosen nut for ad-
ditional adjustment on brake cable.
Securely tighten nut when done.
2
Loosen brake cable anchor and
disconnect cable.
5
Remove wheel.
8
Re-attach chain guard. Test ride
and readjust as needed.
3
Loosen brake housing anchor
and disconnect. Keep spacer and
washers together.
6
Install new chain or wheel by
slipping chain around axle. Slide
axle into the slots on frame. Slide
wheel forward and maneuver chain
onto rear sprocket, motor shaft and
chain tensioner.
5
WARNING: The brake
is capable of skidding the tire and
throwing an unsuspecting rider.
Practice in an open area free from
obstacles until you are familiar with
the brake function. Avoid skidding
to a stop as this can cause you to
lose control or damage the rear tire.
Note: The brake lever contains a
safety switch to stop the motor
when the brake is applied. In an
emergency, applying the brake
will always stop the motor. Do not
disable or replace this lever with
anything other than a genuine Razor
replacement part.
Note arrangement of
hardware:
Right (Throttle)
Safety hook
3/8 Axle locknut
Left (Brake)
Spacer
Safety hook
3/8 Axle locknut