Assembly And Set-Up; Attaching Handlebars - Razor Pocket Mod Owner's Manual

ASSEMBLY AND SET-UP

Attaching Handlebars

1
Remove plastic protector
and insert handlebar assembly
through front fairing and into fork
until it stops. Raise to desired
height keeping the handlebars
and fairing aligned within the red
arrows of the safety zone.
q Attaching Front Wheel
1
Remove packing material
from the front fork.
q Checking Spoke Tension
Spoke
Flange
Spoke
Nipple
1
Verify spoke tension by grasping and shaking each spoke. Spoke
should not be loose from hub. Look for any play between spoke flanges
where it mates with hub. You should not be able to spin any nipple by
hand. If one or more spokes are loose, or if you can turn any nipple us-
ing your fingers, all spokes must be checked and need to be tightened
with a spoke wrench.
2
Tighten down bolt.
2
Insert wheel into front fork with
lock washers on outside of fork.
Hub
Flange
Spoke
Flange
Rim
Nipple
3
Insert tab on lock washer into
hole on front fork and tighten nuts.
19
20
4
3
2
1
2
Start with spoke cloest to tire valve
and tighten each nipple. In sequence,
exactly 1/4 to 1/2 turn. Continue tighten-
ing all spokes no more than 1/2 turn in
sequence until all spokes are tight.
3
WARNING: Failing to
properly adjust and tighten the
clamps and retainers that affix the
handlebar can cause you to lose
control and fall.
WARNING: Regularly
check the spoke tension and
17
retighten the spokes whenever
loose. If you ave any doubt, ask an
18
experienced motorcycle or bicycle
mechanic to inspect your spokes
to determine if the spokes need
tightening or adjusting.
Note: Tightening each nipple more
than a 1/2 turn each can cause the
wheel to become distorted and
wobbly thus permanently damaging
the wheel.