Inflating Tires; Charging The Battery - Razor Pocket Mod Owner's Manual

ASSEMBLY AND SET-UP
q Inflating Tires
1
Inflate tires to PSI indicated
on sidewall of tire.
q Side View Mirror Assembly Instructions (if applicable)
1
Adjust side view mirror
sockets into fixed place and
tighten down.

Charging the Battery

Charge battery prior to use.
• Initial charge time: 18 hours
• Recharge time: up to 12 hours
depending on the level of depletion
Charger
Port
Charger
Plug
2
Insert side view mirrors into
sockets and tighten down nuts.
• Run time: Up to 30 minutes of continuous ride time
• Average battery life: 250 charge/discharge cycles
1
Turn power OFF before charging.
2
4
Note: The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate
your Pocket Mod tires, first make
sure the pressure gauge is working,
then use very short bursts to
inflate to the correct PSI. If you
inadvertently over-inflate the
tires, release the excess pressure
immediately.
WARNING:
Rechargeable batteries are only to
be charged under adult supervision.
Always disconnect your Pocket Mod
from the charger before cleaning
with liquid.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status. Refer
to the illustration on the charger
unit for the actual "charging" and
"charged" status indications for
your model charger.
Chargers have built-in protection
to prevent battery from being over-
charged.
Be sure to properly align the
groove on the charger input
plug with the corresponding
socket on the case; otherwise,
no charging action will occur.