Lubrication; Greasing The Bearings, Bushings, And Pivots - Toro LT3340 Operator's Manual

Lubrication

Greasing the Bearings,
Bushings, and Pivots
Service Interval: Before each use or daily
Every 50 hours
Lubricate all grease fittings for the bearings and bushings
with #2 general-purpose, lithium-based grease. Lubricate
1. – Grease every 50 hours
the bearings and bushings immediately after every washing,
regardless of the interval listed.
Replace any damaged grease fittings.
Grease all cutterhead grease points and ensure that sufficient
grease is injected such that clean grease is seen to escape from
the roller end caps. This provides visible evidence that the
roller seals have been purged of grass and debris and ensures
maximum working life.
The grease fitting locations and quantities are as follows:
Figure 46
2. – Grease daily
36
1
2
G022392