Folding The Rops - Toro LT3340 Operator's Manual

1
2
Figure 37
1. Lock Wheel
g014435
2. Weight transfer hand
wheel

Folding the ROPS

You can fold the ROPS frame down to allow access into areas
of restricted height.
WARNING
While the ROPS frame is folded down it does not
provide any protection in the event of a roll-over and
should not be considered as a Roll Over Protective
Structure.
1. Apply the parking brake and switch off the engine.
2. Support the weight of the upper frame while removing
the hand nuts, washers and retaining bolts from the
pivot brackets (Figure
3. Carefully lower the frame downwards until it rests on
the stops.
4. Insert the retaining bolts in the lower holes and fully
tighten the hand nuts to support the upper frame in
its lowered position.
5. To raise the frame, follow these instructions in reverse
order.
1. Upper frame
2. Hand nuts, washers, and
retaining bolts
WARNING
When in the raised position, both retaining bolt
assemblies must be installed and fully tightened to
ensure full ROPS protection.
28
38).
1
2
3
Figure 38
3. Lower holes
G014436