Folding The Rops - Toro Groundsmaster 3400 Operator's Manual

1
2
3
Figure 23
1. Hydraulic-tank cap
2. Hydraulic-fluid tank
5. Remove the cap and fill the tank to the upper mark on
the sight level gauge. Do not overfill.
6. Install the cap onto the tank.

Folding the ROPS

You can fold the ROPS frame down to allow access into areas
of restricted height.
WARNING
The machine does not have a Rollover Protection
System when the roll bar is folded down and should
not be considered as Rollover Protection System.
Do not wear a seatbelt when the roll bar is lowered.
1. Park the machine on a level surface, shut off the engine,
engage the parking brake, and remove the key from
the ignition switch.
2. Support the weight of the upper frame while removing
the R-clips and pins from the pivot brackets
3. Carefully lower the frame downwards until it rests on
the stops.
4. Insert the pins in the lower holes and secure with
the R-clips to support the upper frame in its lowered
position.
5. To raise the frame, follow these instructions in reverse
order.
G014570
g014570
3. Sight-level gauge
(Figure
1. Upper frame
2. Pins and R-clips
WARNING
The ROPS protection system may not be effective if
the ROPS retaining bolt assemblies are loose which
may cause serious injury or even death in the event
of a rollover.
When in the raised position, both retaining bolt
assemblies must be installed and fully tightened to
ensure full ROPS protection.
WARNING
24).
When lowering and raising the ROPS frame, fingers
may get pinched between the machine and the
ROPS.
Use caution when lowering and raising the ROPS
to prevent entrapment of fingers between fixed part
and pivot part of the structure.
•
Keep all nuts, bolts, and screws correctly torqued ensure
that the equipment is in safe working condition.
•
Replace worn or damaged parts for safety.
•
Ensure that the seat belt and mountings are in safe
working order.
•
Wear the seat belt when the roll bar is raised and no seat
belt when the roll bar is lowered.
20
Figure 24
3. Lower holes
g034908