Brake Fluid - Can-Am 2007 Outlander 500 EFI Operator's Manual

Add coolant up to MAX. mark if re-
quired. Use a funnel to avoid spillage.
Do not overfill.
Properly reinstall and tighten filler cap
and reinstall access panel.
If the coolant is added in the coolant
reservoir, check the level in the radia-
tor too. Add coolant if necessary.
WARNING
In order to avoid getting burned,
do not remove the radiator cap if
the engine is hot.
NOTE: A cooling system that fre-
quently requires coolant is the indica-
tion of leaks or engine problems. See
an authorized Can-Am dealer.
Coolant Replacement
Refer to MAINTENANCE section.

Brake Fluid

Recommended Fluid
Always use brake fluid meeting the
specification DOT 4 only.
CAUTION: To avoid serious dam-
age to the braking system, do not
use fluids other than the recom-
mended one, nor mix different
fluids for topping up.
Fluid Level
With vehicle on a level surface, check
brake fluid in reservoirs for proper lev-
el. They should be above MIN. mark.
Add fluid as required. Do not overfill.
Clean filler cap before removing.
CAUTION: Use only DOT 4 brake
fluid from a sealed container. Do
not use brake fluid taken from old
or already opened containers.
______________________
84
NOTE: A low level may indicate leaks
or worn brake pads. See an autho-
rized Can-Am dealer.
Brake Lever Fluid Reservoir
Turn steering in the straight-ahead
position to ensure reservoir is level.
Check the brake fluid level, the reser-
voir is full when the fluid reaches of
the top of window.
Visually inspect lever boot condition.
Check for cracks, tears, etc. Replace
if damaged.
vmo2006-016-004_a
TYPICAL
Brake Pedal Fluid Reservoir
vmo2006-007-017_a