Gearbox Oil; Engine Coolant - Can-Am 2007 Outlander 500 EFI Operator's Manual

Table of Contents

Advertisement

Repeat the above procedures until
oil level reaches the dipstick's upper
mark. Do not overfill.
Properly tighten dipstick.

Gearbox Oil

Recommended Oil
Use XP-S chaincase oil (P/N 413 801
900) or an equivalent.
CAUTION: Do not use unrecom-
mended other types of oil when
servicing. Do not mix with other
types of oil.
Gearbox Oil Level
CAUTION: Check level and refill if
necessary. Do not overfill. Oper-
ating the gearbox with an improp-
er level may severely damage gear-
box. Wipe off any spillage.
Place the vehicle on a level surface.
Select NEUTRAL position then apply
parking brake.
Check the gearbox oil level by remov-
ing the gearbox oil level plug.
vmo2006-007-018_a
1. Oil level plug
2. Oil drain plug
The oil should be level with the bottom
of the oil level hole. Refill as required
until gearbox oil level flows through oil
level hole.
To change gearbox oil, refer to MAIN-
TENANCE section.

Engine Coolant

Recommended Coolant
Always use ethylene-glycol antifreeze
containing corrosion inhibitors specifi-
cally for internal combustion aluminum
engines.
Cooling system must be filled with
BRP premixed coolant (P/N 219 700
362) or with distilled water and an-
tifreeze solution (50% distilled water,
50% antifreeze).
Coolant Level
Check coolant level with engine
cold. Never add coolant in cool-
ing system when engine is hot.
Remove access panel.
vmo2006-007-016_a
With vehicle on a level surface, liquid
should be between MIN. and MAX.
level marks of coolant reservoir.
NOTE: When checking level at tem-
perature lower than 20°C (68°F), it
may be slightly lower than MIN. mark.
_____________________
WARNING
83

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2007 outlander 650 efi2007 outlander 800 efi

Table of Contents