Yamaha 40 Installation Manual page 40

6. Check:
• Shift operation
Unsmooth operation → Adjust.
Checking steps:
• Turn the throttle grip to the fully closed
position.
• Check the shift lever for smooth operation
by shifting the lever from neutral to forward
and reverse.
7. Adjust:
• Throttle cable joint position
Adjustment steps:
• Turn the throttle grip to the fully closed
position.
• Turn the magneto control lever 1 so that
its adjusting screw contacts the fully
retarding stopper a.
• Turn the shift lever to the forward position.
• Adjust the position of the cable joint until
its hole aligns with the set pin.
• Install the clip 2, and then tighten the
locknut 3.
WARNING
The cable joint must be screwed in a
minimum of 8.0 mm (0.31 in).
31
E