Table of Contents
Advertisement
Base station settings
The base settings are carried out using a reg-
istered Gigaset handset.
Activating/deactivating
music on hold
¤ Settings ¤ Telephony
§Menu§
¤ Music on hold
§OK§
Press
to activate or deactivate music on
hold (³= on).
Activating repeater support
With a repeater, you can increase the range
and signal strength of your base. You will
need to activate repeater mode. This will ter-
minate any calls that are in progress at the
time.
Prerequisite: A repeater is registered.
¤ Settings ¤ System
§Menu§
¤ Repeater Mode
§OK§
Press
to activate/deactivate repeater
³
mode (
= activated).
After activating or deactivating the
repeater, switch your handset off and
on again (¢ page 19).
Please note
u Eco Mode / Eco Mode+ (¢ page 38)
and repeater support cancel each
other out, i.e., you cannot use Eco
Mode and Eco Mode+ when using a
repeater.
u The default encrypted transmission
setting is deactivated when a
repeater is activated.
Protecting against
unauthorised access
Protect the system settings of the base
station with a PIN known only to yourself.
The system PIN must be entered when,
for example, registering/de-registering a
handset to/from the base or when restoring
the default settings.
Changing the system PIN
You can change the 4-digit system PIN set on
the base (default setting: 0000) to a 4-digit
PIN known only by you.
¤ Settings ¤ System ¤ System PIN
§Menu§
~
Enter the current system PIN
and press
~
Enter your new system PIN and
§OK§
press
Resetting the system PIN
If you have forgotten your system PIN, you
can reset the base to the original code 0000:
Disconnect the power cable from the base.
Hold down the registration/paging key on
the base while reconnecting the power
cable to the base. Hold down the key for at
least 5 seconds.
The base has now been reset and the system
PIN set to 0000.
Please note
All handsets are de-registered and must
be re-registered. All settings are reset to
the default settings.
Base station settings
§OK§
.
.
45
Advertisement
Table of Contents
