NETGEAR D7000 User Manual page 67

Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000
11. Enter the VDSL settings as described in the following table.
Field
Multiplexing Method
VPI
VCI
Use VLANID
Priority (0 ~ 7)
Bridge Mode
Encapsulation
Login
Password
Service Name
Description
These settings are disabled because they do not apply to a VDSL connection.
Select the Use VLANID check box and enter the VLAN ID, as indicated by your ISP.
A VLAN ID might be required if you subscribe to both Internet service and IPTV
service. In some unusual situations, a VLAN ID is required for VDSL Internet service.
If your ISP did not provide you with a VLAN ID, leave the Use VLANID check box
cleared, which is the default setting.
If your ISP provided you with a VLAN ID and a priority value, enter the priority value,
which is a number from 0 to 7.
You can enter a priority value only in combination with a VLAN ID. If your ISP did
not provide you with a priority value, leave the default setting (0).
This setting is an option that applies to the IPTV interface only.
For information about configuring bridge mode, see
Devices on page 202.
For a PPP over Ethernet (PPPoE) connection, select PPPoE (PPP over Ethernet)
from the menu.
Note PPP over ATM (PPPoA) is not supported for a VDSL connection.
Enter the login name that you use to log in to your Internet service, as indicated by
your ISP.
This login name is often an email address.
Enter the password that you use to log in to your Internet service, as indicated by
your ISP.
Enter the service name that you use to log in to your Internet service, as indicated
by your ISP.
Often, a service name is not required.
Manage the Internet Settings Manually
67
Enable Bridge Mode for IPTV