NETGEAR D7000 User Manual page 52

Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000
Field
Multiplexing Method
VPI
VCI
Use VLANID
Priority (0 ~ 7)
Bridge Mode
Description
Select LLC-BASED or VC-BASED, as indicated by your ISP.
The multiplexing method can either be virtual circuit (VC) based or logical link control
(LLC) based.
Note This setting does not apply to the IPTV interface.
Enter a number between 0 and 255 for the virtual circuit number for the virtual path
identifier (VPI), as indicated by your ISP.
If your ISP did not provide you with a VPI setting, leave the default setting (8). The
VPI might be required not only for a VC-based connection but also for an LLC-based
connection.
Note This setting does not apply to the IPTV interface.
Enter a number between 32 and 65535 for the virtual circuit number for the virtual
channel identifier (VCI), as indicated by your ISP.
If your ISP did not provide you with a VCI setting, leave the default setting (35). The
VCI might be required not only for a VC-based connection but also for an LLC-based
connection.
Note This setting does not apply to the IPTV interface.
Select the Use VLANID check box and enter the VLAN ID, as indicated by your
ISP.
A VLAN ID might be required if you subscribe to both Internet service and IPTV
service. If your ISP did not provide you with a VLAN ID, leave the Use VLANID
check box cleared, which is the default setting.
If your ISP provided you with a VLAN ID and a priority value, enter the priority value,
which is a number from 0 to 7.
You can enter a priority value only in combination with a VLAN ID. If your ISP did
not provide you with a priority value, leave the default setting (0).
This setting is an option that applies to the IPTV interface only.
For information about configuring bridge mode, see
Devices on page 202.
Manage the Internet Settings Manually
52
Enable Bridge Mode for IPTV