NAPCO Gemini GEM-X255 Programming Instructions Manual page 53

WI1092B 9/02
NEW COMPAT# 0000
not be removed for use on a system with a different compatibility number. Press the
the button to exit.
C
EZM ADDRESS 01
designate the keypad as Group "01" at the "
number "01" through "22". (Each EZM must have a unique assigned group number, starting with "01" and proceeding
consecutively.) Press the
Zone Response
ZONE RESPONSE 00
3. At the keypad, enter the sum as a two-digit number "01" through "15" on the display, then press the
Example. Change Zones 2, 3 and 4 to 50mS response.
1. Circle numbers for Zones 2, 3 and 4: (2), (4) and (8).
2. Add up the circled numbers: 2 + 4 + 8 = 14.
3. Enter "14" at the keypad, then press the
Press the button to continue or press the
A
01 OUT OF SYSTEM
" "). Then replace Jumper JP5 across Pins 1–2 (top two).
L
NAPCO Security Systems
Compatibility Number
The compatibility number is a 4-digit security code that, if programmed into
both the control panel and each GEM-RP1CAe2 keypad, dedicates the
keypad to only that panel. That is, (a) similar keypads not having the correct
compatibility number will not operate in the system and (b) a keypad may
EZM Address
The keypad's internal EZM (Expansion Zone Module) may be utilized to
provide four additional wired zones. Whether used alone or in conjunction
with optional GEM-EZM series modules or other keypad EZMs, it must be
assigned a unique address (or Group number, see Keypad Programming
Workbook) similar to its keypad address. If no other EZMs are to be used,
EZM ADDRESS 00
J
button. Press the
A
The normal loop response of each keypad expansion zone is 750mS,
however the response time of any zone can be reduced to 50mS as follows.
1. Of the following, circle the number(s) in parentheses associated with the
zone(s) to be changed:
Zone 1=(1); Zone 2=(2); Zone 3=(4); Zone 4=(8)
2. Add up the circled numbers.
J
button.
C
" display. In multiple-EZM systems, enter an assigned group
button to continue or press the
button to exit the Keypad Configuration Mode (display will read
X
GEM-X255 Programming Instructions
Page 53
button to continue or press
A
button to exit.
C
J
button.
!