Wi1092B - NAPCO Gemini GEM-X255 Programming Instructions Manual

GEM-X255 Notes:
or a GEM-X255 system comprising 96 zones or less, the system may be keypad programmed. A system
! F
larger than 96 zones must be downloaded with NAPCO PCD-Windows Version 4.1. This manual contains
Easy Program Mode instructions, which allows the the first 96 zones to be completely programmed through
Menu Driven Easy Program Mode.
! The GEM-X255 requires the use of version 7 firmware GEM-RP1CAe2 7 keypads:
The keypad version can be identified by a compatibility sticker on keypad carton as well as a product
version number of 07. The product version number appears as a 2 digit number which follows a 5 digit date
code stamped on the the inside end flap of the carton (ex: XXXXX07DR). This number will also appear on
the product on a triangular shaped sticker.
The firmware version of the keypad can also be ascertained by entering the program mode—it will read
[2307 Program Mode].
! The GEM-X255 requires the use of version 7 firmware GEM-EZM-8 zone expansion modules.
This version zone expansion modules can be identified by a compatibility sticker on the keypad carton as well as a
product version number of 11. The product version number appears as a 2 digit number which follows a 5 digit date
code stamped on the carton (ex: XXXXX11DR). This number will also appear on the on the the inside end flap of
the carton as well as on the circuit board on a triangular shaped sticker.
System features
Chime 2 zone provides second distinct
!
pulsating "Chime Zone" tone
Set System Time and Date in User Program
!
Mode
System Trouble Audible Automatic Timeout
!
Inhibit System Trouble Audible
!
Easy Programming of PC Preset Auto
!
download ID and Callback Numbers
Support of GEM-PRINT module
!
Cancel Reporting Code
!
The following changes have been made to this manual (WI1092B) since the previous edition (WI1092A):
Page 22, Address 4089 – Answer on Rings changed from "1-9" to "3-9".
Page 25, CS REPORTING CODES – Addresses added for "Telemetry Trouble" and "Telemetry Fail".
Page 25, CS REPORTING CODES, Address 0896 – Changed "RF Receiver Tamper" to "RF Tamper".
Pages 33-37, ZONE OPTIONS: Duplicate addresses corrected.
Page 39, Address 2417 – "Ans. Machine P/U w/o Line Seizure" deleted.
Page 40, Address 2421, Bit 1 – Changed "Don't Clear Aux. Relay with Arm/Disarm" to "Don't Clear Aux. Relay with Disarm"
Page 40, Address: 2421, Bit 8 – Changed "Aux. Output Chirp on Keyfob Arming" to "Aux. Output Chirp on Keyfob Arm/
Disarm"
CHANGES FROM PREVIOUS EDITION
NAPCO Security Systems, Inc.
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com
Wireless Trouble Reporting by Zone
!
Pager (Telco 3) Reporting Delay
!
Pager - Programmable Number of Reports of
!
Same Signal
Pager - Maximum Number of Consecutive
!
Pages
Specific Logging of Communication Failure
!
Modes
New Relay Event "Area Disarmed" (PCD-
!
Windows programmable only)
Programmable DST start date (PCD-Windows
!
programmable only)