Valet Mode; Power Save; Rapid Resume; Car Select - Viper 5606V Owner's Manual

Hide thumbs Also See for 5606V:

Table of Contents

Valet Mode

Valet Mode can be entered and exited by performing the Remote

Valet command or manually using the vehicle key and the control

button. When entered, the alarm functions are defeated while the

convenience features still operate normally.

Use the following steps to manually enter and exit Valet Mode:

Turn the ignition switch on, and then off.

Immediately press and release the Control Center button once.

The Control Center LED turns on when entering, and off when

exiting.

To reduce power consumption the control center status LED modifies

its output if the vehicle is parked for an extended period. If Armed the

flashing is reduced after 24 hours. When Valet Mode is ON, the LED

turns off after one hour, and resets each time the ignition is turned off.

If power is ever disconnected by a mechanic or thief, the system re-

tains and returns to the last state it was in at the time of disconnection,

once power is reconnected.

Car 2 remote control option must first be turned ON (see under "Re-

mote Control Configuration" on page 14 to turn on). Press and

AUX

hold the

button for three seconds. The LED flashes once or twice to

indicate the selected Car is 1 or 2, release the button for Car Select,

or continue to hold for programming.

Release the

es continue to perform Car Select. Once the car is selected a com-

mand can be performed by pressing one of the command buttons.

AUX

button, then press and release while the LED flash-

Table of Contents