Table of Contents
Advertisement
Valet Mode
Valet mode can be entered and exited by performing the Remote Valet
command or manually using the vehicle key and the control button.
When entered, the convenience features still operate normally.
Use the following steps to manually enter and exit Valet Mode:
Turn the ignition switch On and then Off
1.
Immediately press and release the control button once
2.
3.
The control center LED turns On when entering and Off when
exiting.
Power Save
To reduce power consumption the control center status LED modifies
its output if the vehicle is parked for an extended period. If Locked the
flashing is reduced after 24 hours. When Valet mode is On the LED
turns off after 1 hour and resets each time the ignition is turned off.
Power Save extends battery life by turning Paging Off after 72 hours if
the remote control is not used during this period. Just press any button
to resume system monitoring. Power Save 2 is for maximum battery
life and will monitor the system only when remote start has been acti-
vated. See "Page Mode*" on page 18 .
Rapid Resume
If power is ever disconnected by a mechanic or thief, the system will
resume the state it was in at the time of disconnection, when power
is reconnected.
Automatic Remote Updates
The system sends a silent message to all remote controls after any
major action has occurred. When the remote receives this message it
updates the Lock status.
© 2013 Directed. All rights reserved.
27
Hide quick links:
Advertisement
Table of Contents
