Panic Mode; Valet Mode - Viper 3105V Owner's Manual

Panic mode

If you are threatened in or near your vehicle, you can attract attention
by triggering the system with your remote.
Press for approximately two seconds, to enter Panic Mode. The
siren sounds and the parking lights flash for the programmed siren
duration. To stop Panic Mode at any time, press the

Valet mode

You can prevent your security system from automatically arming and
trig ger ing by using Valet Mode. This is very useful when washing the
ve hi cle or having it serviced. In Valet Mode, the security system will
not arm, even with the remote trans mit ter, but all convenience functions
(door locks, trunk re lease, etc.) will continue to work nor mal ly.
To enter or exit Valet Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet switch within 10 seconds.
The status LED lights solidly if you are en ter ing Valet Mode, and goes
out if you are exiting Valet Mode.
To enter or exit Valet Mode with the remote:
Open any vehicle door, and then quickly press the following buttons
in the sequence indicated.
4. Press .
AUX
5. Press
lights solidly if you are entering Valet Mode, and goes out if you
are exiting Valet Mode.
© 2012 Directed. All rights reserved.
and then press again. The in - vehicle status LED
.
13