Sensor Warn Away; Full Trigger Output; Emergency Override; Trigger Zone Fault Report - Viper 5606V Owner's Manual

Hide thumbs Also See for 5606V:

Table of Contents

Sensor Warn Away

When the system sensors detect a Warn Away trigger the siren chirps

and parking lights flash for three seconds.

An alarm Full Trigger will sound the siren and flash the parking lights

for 30 seconds.

The following procedure disarms the system when a programmed re-

mote is not available. Number of presses__________

Turn the ignition on.

Press and release the Control Center button the correct num-

ber of times (the default is one press).

After a few seconds the siren output ceases and the system

is disarmed.

Note

As a precaution, if programmed for Passive Arming or Auto

re-arming the system should be placed into Valet Mode until

a remote is available .

When armed by remote command the system runs a status check of

the alarm trigger zones. Faulty zones (usually caused by dome light

delay or open trunk) are bypassed and reported via the control center

LED, while all other trigger zones remain active and are monitored to

protect the vehicle. Should a faulty zone self correct (dome light turns

off) it becomes active and is then monitored normally.

The siren chirps once again a few seconds following the arming

chirps as an audible alert, the control center LED flashes in groups to

indicate the zone number.

Table of Contents