Fuji Xerox ApeosPort-II C7500 Administrator's Manual page 365

Category
Error Code
C P S M O
116-748 O
116-749 O
116-752 O
116-780
116-790
O
124-701
124-702
124-703
124-704
124-705 O
124-706 O
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
[Cause] There is no plot data in the HP-GL/2 print data.
[Remedy] Check the print data.
[Cause] The job was cancelled because the specified font does not
exist.
[Remedy] Install the font, or set the font replacement on the print driver.
[Cause] The descriptions of the PDF printing job ticket have a problem.
[Remedy] Try again. If the problem persists, contact our Customer
Support Center.
O O [Cause] There is a problem with the document attached to the received
e-mail.
[Remedy] Check the attached document.
[Cause] 1. If the operator cancelled printing a document that was
received using the Fax to Mailbox or iFax to Mailbox
feature:
The first set of the document is not stapled.
2. For a cause other than Cause 1:
All the sets of the document are not stapled.
[Remedy] For Cause 1. Manually staple the first set of the document. Or,
do not cancel printing a document that is received using the
Fax to Mailbox or iFax to Mailbox feature.
For Cause 2. Check if the staple position has been correctly
specified, and try printing again.
O [Cause] The output destination was changed to the center tray due to
the malfunction of the specified output tray.
[Remedy] Contact our Customer Support Center. Any trays other than
the defective output tray can be used.
O [Cause] The output destination was changed to the center tray due to
the malfunction of the specified Finisher tray.
[Remedy] Contact our Customer Support Center. Any trays other than
the defective output tray can be used.
O [Cause] The output destination was changed to the center tray due to
the malfunction of the specified booklet tray.
[Remedy] Contact our Customer Support Center. Any trays other than
the defective output tray can be used.
O [Cause] The output destination was changed to the center tray due to
the malfunction of the specified output tray.
[Remedy] Contact our Customer Support Center. Any trays other than
the defective output tray can be used.
[Cause] The punch setting was cancelled.
[Remedy] Check the punch position, and try again.
[Cause] The folding setting was cancelled.
[Remedy] Check the folding setting, and try to print again.
Cause and Remedy
Error Code
14
363