Trouble Shooting - Nexgrill Stainless Steel Gas Grill 720-0050-LP Use And Care Manual

TROUBLE SHOOTING

PROBLEM
When I light the grill it does not flame
immediately.
Rotisseries burner will not light when
the igniter button is pushed.
Regulator makes noise.
Full size cover does not fit the grill.
SOLUTION
--Make sure you have turn on the gas
--Make sure it has spark while you are trying to
ignite the burner.
--Push in for approximately 5 second before to turn
and ignite the grill.
--Make sure your burner is clean.
--Check to see if debris is blocking the
sparks.
--Check to see there is spark that jumps to the
burner from the electrode wire. If no spark is
seen.
--Check the battery located inside the button. Press
and turn counter clockwise.
--Check for loose wire connection.
--Gently bend the electrode wire closer to the
burner until a spark is seen to jump from the
igniter to the burner when you press the starter
button.
--Dose the infrared back burner light when
attempting to match light? If not, check did you
turn on the gas.
--Vent hose on the regulator may be plugged or
regulator may be faulty.
--Ensure the vent hole on the regulator is not
obstructed. Clear the hole, close the LP tank and
gas control valves. Wait ten minutes and re-start.
--When turning the LP tank valve on, do not cover
vent hole on the regulator.
--Check your flames for proper performance if the
flames are not correct replace regulator.
--Cover may be incorrect for your grill. It may be a
tight fit. Ensure the cover correct length for your
grill. Measure it left to right. Compare to the grill's
measurement.
--Compare the location and size of the hood portion
of the cover to your grill.
--Spread the cover and allow it to relax, preferably
in warm sunlight or in a warm room.
18
electrode