Mount The Camera - COMPRO TN50 User Manual

Hide thumbs Also See for TN50:
Table of Contents

Advertisement

Compro TN50 Network Camera

Mount the Camera

If desired, you can mount the camera on a wall or ceiling. The following section explains how to mount your
camera.
1. Drill 2 mounting holes on the mounting surface. While you are at it, bear in mind that there will have to be
a minimum space of 2.5 mm (0.098 inch) between the screw head and the mounting surface. Also, the 2
mounting holes on the wall or ceiling should be spaced exactly 31 mm (1.22 inch) apart to correspond
to the position of screw holes on the camera's bracket base. Then, if you're mounting on a concrete wall,
insert a screw anchor into each of the mounting holes.
2. Loosen the fastening hex nut to detach the bracket from the camera.
3. Remove the base cover by inserting a flat blade screwdriver into the small hole on the bracket base and
then pressing the screwdriver downward.
4. Put a screw into each of the mounting holes. Then secure the bracket to the mounting surface.
5. Finally, click the base cover back into position. After that, attach the camera body back to the bracket
and then adjust the camera to the desired viewing angle.
3-10 Mount the Camera
STEP 1
STEP 1
31mm
31mm
31mm
31mm
Bracket
Base
Bracket
Base
STEP 2
STEP 2
Fastening Nut
STEP 3
Fastening Nut
STEP 3
Base
Cover
Base
Cover
STEP 4
STEP 4
STEP 5
2.5mm
2.5mm

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tn50w

Table of Contents