Panel Button Command; Paper Sensor Commands - Epson U590P Information Manual

CONFIDENTIAL
ESC f t1 t2 sets the time from detection of the slip to the start of printing to t2 × 0.1 seconds. t1 is
always set to 0 second. When t1=0, the printer continues waiting for a slip to be inserted. The
defaults are t1=0, t2=5. This setting alone, however, does not cause the printer to immediately start
waiting for a slip to be inserted. The setting becomes effective when slip, check paper (only with the
MICR reader), or cleaning sheet (only with the MICR reader) is used. DLE ENQ is used to cancel the
check paper or cleaning sheet waiting state.
PRINT #1, CHR$(&H1B);"f";CHR$(0);CHR$(20);

Panel Button Command

The TM-U590/U590P supports the following command for enabling and disabling the panel buttons.
(FORWARD, REVERSE, and RELEASE).
Command
ESC c 5
ESC c 5 n
[Name]
[Format]
[Range]
ESC c 5 n enables or disables the panel buttons. When the LSB (least significant bit) of n is 1, all
buttons are disabled; when it is 0, all buttons are enabled. The default is n=0. To prevent problems
caused by accidentally pressing the buttons, use this command to disable the buttons. When the
panel buttons are enabled by this command, if the cover is open, paper cannot be fed or released.
PRINT #1, CHR$(&H1B);"c5";CHR$(1); ←

Paper Sensor Commands

The TM-U590/U590P supports the following commands for controlling the paper sensor(s) that stop
printing and output paper-end signals:
Command
ESC c 4
ESC c 3
Rev. A
Program Example
Name
Enable/disable panel buttons
Enable/disable panel buttons
ASCII ESC
Hex 1B
Decimal 27
0 ≤ n ≤ 255
Program Example
Name
Select paper sensor(s) to stop printing
Select paper sensor(s) to output paper-end signals
TM–U590/U590P Information Manual
c 5 n
63 35 n
99 53 n
Disable panel buttons
Command Descriptions 1-19