Instrument Lighting Dimmer - Ford RANGER Owner's Manual

Once the system is active the high beam
will switch on if:
• It is dark enough to require the use of
high beams and
• there is no traffic or street lighting
ahead and
• vehicle speed is greater than
approximately 40 km/h.
The high beam will switch off if:
• The ambient light is high enough that
high beam is not required.
• An approaching vehicle's headlamps
or tail lamps are detected.
• Street lighting is detected.
• Vehicle speed falls below
approximately 25 km/h.
• The camera sensor is too hot or
becomes blocked.
Activating the System
Switch the system on using the information
display. See General Information (page
66). Turn the switch to the autolamps
position. See Automatic High Beam
Control (page 46).
E142451
The indicator will illuminate to confirm
when the system is ready to assist.
Lighting
Manually Overriding the System
E169254
Push or pull the lever to switch between
high and low beam.
Note: This is a temporary override and the
system will return to automatic operation
after a short period.
To permanently switch the system off, use
the information display menu or turn the
lighting control switch to the headlamps
position.
INSTRUMENT LIGHTING
DIMMER
E133586
Press it repeatedly or press it and hold it
until the desired level is reached.
47