Intermittent Wipe
Type 1
A
E131453
A
Long wipe interval
B
Intermittent wipe
C
Short wipe interval
Type 2
A
E167119
A
Short-wipe interval.
B
Intermittent wipe.
C
Long-wipe interval.
Push the wiper lever up to switch the
wipers on, and then use the rotary control
to adjust the intermittent wipe interval.
Wipers and Washers
B
C
C
Speed Dependent Wipers
When your vehicle speed increases, the
interval between wipes decreases.
AUTOWIPERS
Auto Wipers
Type 1
Note: Fully defrost the windshield before
switching on the windshield wipers.
Note: Make sure you switch off the
windshield wipers before entering a car
wash.
Note: Clean the windshield and wiper
blades if they begin to leave streaks or
smears. If that does not resolve the issue,
install new wiper blades.
Note: During wet or winter driving
conditions with ice, snow or a salty road
mist, inconsistent or unexpected wiping or
smearing may occur.
B
In these conditions, you can do the
following:
•
Lower the sensitivity of the autowipers
to reduce the amount of smearing.
•
Switch to normal or high-speed wipe.
•
Switch the autowipers off.
Note: Make sure the wiper is switched off
before switching the ignition off. Otherwise,
the wipers will stop at the current operating
position.
39