Ford RANGER Owner's Manual page 19

Installation of a child restraint anchor
fitting – Double Cab
The following illustration shows how to
install anchor fittings to the anchorage
points. Child restraint anchor fittings
conforming to Australian Standard
AS1754-2004 (or later) can be purchased
from child restraint manufacturers or
suppliers.
The anchorage components must be
selected and assembled as shown in the
illustration.
5mm
E134044
Install the standard 30mm bolt and the
5mm spacer, together with the anchor
fitting and lock washer supplied with the
child restraint as illustrated.
Child Safety
3
17
The bolt thread should protrude at least
10mm beyond the spacer with the lock
washer, anchor fitting and spacer
assembled together.
Tighten the bolt with the anchor fitting
facing toward the front of the vehicle as
shown.
WARNING
Do not over-tighten the attachment
bolt. Maximum torque: 20 Nm
The diagram below shows the correct
installation and orientation of the
attaching clip and anchor fitting.
E212688
Illustrations of the restraint attaching clip
and anchor fitting are only applicable to
child restraints conforming to Australian
Standard AS1754-2004 (or later) . If your
child restraint does not have an approved
latched hook attachment clip as shown,
you should consult an approved Restraint
Fitting Station.
WARNINGS
Always ensure that the attaching clip
is properly engaged with the anchor
fitting and the tether strap length is
adjusted to remove any slack.