Refitting The Engine - 950 Adventure - KTM 2003 950 Adventure Repair Manual

3-7
1
2
3
4
6
8

Refitting the engine - 950 Adventure

– Before mounting the engine, attach the water, SLS and vacuum
– Position the swing arm and fix with the swing arm pivot on the right
– Lift the engine into the frame with the trolley jack, insert the sealing
– Guide the chain along the side of the pinion and insert the swing
– Insert the bolt
– Remove the trolley jack attachment 600.29.055.100 from the
– Plug the connector on the oil pressure switch
5
– Screw on the ground wire connection
– Attach the pulse generator connector
7
– Position the foot brake pedal, apply Loctite 243 to the bolt
hoses (Öttiger clamps - special pliers 600.29.057.000 or spring-
loaded band-type clamps - special pliers 600.29.057.100)
and a suitable pipe on the left.
washer in the rear exhaust flange and secure with copper paste if
necessary.
arm pivot , screw on the nut but do not tighten yet.
1
in the lower support (raise or lower the engine
2
slightly if necessary).
engine.
sensor and the front and rear ignition coil
4
fasten the wiring harnesses.
tighten to 25 Nm.
, the temperature
3
. Use cable clips to
5
.
6
.
7
and
8