Refitting The Engine - KTM 950 ADVENTURE 2003 Manual

3-7
1
2
3
4
6
5
7
8

Refitting the engine

– Before mounting the engine, attach the water, SLS and vacuum hoses
(Öttiger clamps - special pliers 600.29.057.000 or spring-loaded
band-type clamps - special pliers 600.29.057.100)
– Position the swing arm and fix with the swing arm pivot on the right
and a suitable pipe on the left.
– Lift the engine into the frame with the trolley jack, insert the sealing
washer in the rear exhaust flange and secure with copper paste if
necessary.
– Guide the chain along the side of the pinion and insert the swing arm
1
pivot , screw on the nut but do not tighten yet.
2
– Insert the bolt in the lower support (raise or lower the engine
slightly if necessary).
– Remove the trolley jack attachment 600.29.055.100 from the engine.
– Plug the connector on the oil pressure switch
4
sensor and the front and rear ignition coil
fasten the wiring harnesses.
– Screw on the ground wire connection
– Attach the pulse generator connector
– Position the foot brake pedal, apply Loctite 243 to the bolt
tighten to 25 Nm.
3
, the temperature
5
. Use cable clips to
6
.
7
.
8
and