Generator Cover; Rotor - KTM 2003 950 Adventure Repair Manual

4-11
4
3
9
– Insert the pressure tool 600.29.031.000
2
1
– Remove the balance weight
– Slip off the timing chain and pull the engine sprocket off of the
– Unscrew the chain tensioning rail
NOTE:
– if you intend to reuse the timing chain, engine sprocket and chain
– If you cannot remove the balance weight from the balancer shaft,

Generator cover

– Loosen all of the bolts on the generator cover except the bolt on the
5
6
NOTE: the rotor's magnetic retaining force will prevent the cover from
being removed easily.
– Bend up the lock washer, unscrew the nut

Rotor

– Remove the upper starter idler gear
7
– Remove the rotor bolt
8
– Screw the pressure screw
T
HE HOLE IN THE CRANKSHAFT HAS A FINE THREAD FROM THE
YOU USE THE PRESSURE SCREW
THREAD
– Pull the rotor off of the crankshaft using the puller 600.29.009.000
bk
turn the balance weight up and pull the primary pinion
crankshaft with the puller 600.29.033.000.
the woodruff key out of the shaft groove with a screwdriver.
balancer shaft.
tensioning rail, mark the running direction and the cylinder
allocation.
pull it off using the
600.29.058.000.
starter idler shaft and remove the generator cover, being careful
5
not to lose the dowel pins. Discard the gasket.
sprocket together with the lock washer.
and the washer.
8
model) or 600.29.009.110 (from the 2005 model) into the
crankshaft.
! CAUTION
.
; remove the pressure bolt and the engine locking bolt.
bk
in the crankshaft bore,
1
from the balancer shaft; carefully pry
3
.
4
extractors 590.29.021.044
and remove the engine
6
.
7
600.29.009.010 (up to the 2004
9
!
2005
600.29.009.010
YOU WILL DESTROY THE
off the
2
and
. I
MODEL F