Replacing The Swing Arm Bearing - KTM 2003 950 Adventure Repair Manual

4
7
6
8
1
2
3
7
5
9

Replacing the swing arm bearing

– Dismount the rear wheel (see page 10-3).
– Dismount the splash protector
– Remove the lower shock absorber bolt
down to release the shock absorber from the recess in the swing
arm.
– Remove the foot brake cylinder (950/990 Adventure only), pull the
brake caliper back and out of the guide and fasten the foot brake
cylinder again; do not tighten the bolts.
– Tilt the brake caliper to the side and detach the brake hose from the
brackets.
– Loosen the nut on the swing arm bolt
bolt out with a suitable tube. Pull the swing arm back and remove.
– Remove the outer tappet for the shaft seal ring
tappet
– Pry out both shaft seal rings
– Place the anvil dolly 600.29.056.000
needle bearing
B
584.29.086.000
NOTE: the procedure for the second swing arm bearing is identical
except that the stop disks
A
– Place the anvil dolly 600.29.056.000
new needle bearing into the swing arm with special tool
584.29.086.000
– Press in both shaft seal rings until flush.
– Slide the inner tappet for the shaft seal ring
6
NOTE: the procedure for the second swing arm bearing is identical
except that the stop disks
B
– Position the swing arm on the motorcycle, knock in the swing arm
bolt and tighten the nut to 130 Nm.
– Press the shock absorber into the recess in the swing arm (see
C
renewing the shock absorber), tighten bolt with 80 Nm.
– Remove the bolts on the foot brake cylinder, push the brake caliper
into the guide from behind and mount the foot brake cylinder again.
Secure the bolts with Loctite 243 and tighten to 10 Nm (950/990
A
Adventure only). Press the brake hose into the bracket.
– Remount the rear wheel (to remount, see page 10-3) and the splash
protector.
– Adjust the chain tension (see Owner's Manual).
9
and inner sleeve out of the bearing.
5 6
7
out of the swing arm using the special tool
8
.
B
also need to be removed.
9
and 600.10.013.000
B
into the bearing and press in the outer tappet.
need to be mounted.
9
.
1
and press the swing arm
2
and knock the swing arm
3
and pull the inner
4
.
underneath and press the
A
underneath and press the
A
until flush.
C
and the inner sleeve
5
10-12