Vehicle Speedometer Sensor (Vss) Removal/Installation; Solenoid Valve Inspection - Mazda 2002 6 Workshop Manual

VEHICLE SPEEDOMETER SENSOR (VSS) REMOVAL/INSTALLATION

Caution
• Water or foreign objects entering the connector can cause a poor connection or corrosion. Be
sure not to drop water or foreign objects on the connector when disconnecting it.
• If foreign materials are stuck to the VSS, disturbance by magnetic flux can cause sensor output to
be abnormal and thereby negatively affect control. Make sure that foreign materials such as iron
filings are not stuck to the VSS during installation.
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Disconnect the VSS connector.
4. Remove the VSS.
5. Apply ATF to a new O-ring and install it on a new
VSS.
6. Install the VSS.
Tightening torque
8—11 N·m {82—112 kgf·cm, 71—97 in·lbf}
7. Connect the VSS connector.
8. Install the under cover.
9. Connect the negative battery cable.
End Of Sie

SOLENOID VALVE INSPECTION

Resistance Inspection (On-Vehicle Inspection)
Caution
• Water or foreign objects entering the connector can cause a poor connection or corrosion. Be
sure not to drop water or foreign objects on the connector when disconnecting it.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See
3. Disconnect the transaxle connector.
Note
• When inspecting the pressure control
solenoid, connect the ground connection to
the ground terminal (terminal I) of the
pressure control solenoid inside the solenoid
valve connector.
K–26
AUTOMATIC TRANSAXLE
F–10 INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
A6E561401030W06
A6E5614W037
A6E5614W037
A6E561421280W01
A6E5614W021