ABS (ABS/TCS) HU/CM REMOVAL/INSTALLATION
Caution
• When replacing the ABS (ABS/TCS) HU/CM, configuration procedure must be done before
removing the ABS (ABS/TCS) HU/CM. If configuration is not completed before removing the ABS
(ABS/TCS) HU/CM, TCS will not work properly (with TCS model).
• Do not drop the ABS (ABS/TCS) HU/CM. Replace it if it is subjected to an impact.
1. Configurate the ABS (ABS/TCS) HU/CM (when only replacing it). (See
CONFIGURATION.)
2. Remove the battery, battery tray and battery tray bracket. (See
3. Remove the under cover.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
1
Brake pipe
2
Connector
(See
P–29 Connector Removal
(See
P–29 Connector Installation Note
P–28
ABS/TCS
.
Note)
P–29 ABS (ABS/TCS) or DSC HU/CM
G–3 BATTERY
REMOVAL/INSTALLATION.)
3
ABS HU/CM
(See
P–29 ABS HU/CM Removal/Installation
4
Stud
A6E692143700W01
A6E6921W002
Note)