Transaxle Fluid Temperature (Tft) Sensor Removal/Installation; Oil Pressure Switch Inspection - Mazda 2002 6 Workshop Manual

5. Measure resistance between the terminals of the
TFT sensor.
• If not as specified, replace the TFT sensor.
(See K–21 TRANSAXLE FLUID
TEMPERATURE (TFT) SENSOR REMOVAL/
INSTALLATION.)
ATF temperature (°C {°F})
-20 {-4}
0 {32}
20 {68}
40 {104}
60 {140}
80 {176}
100 {212}
120 {248}
130 {266}
6. Disconnect the TFT sensor from the transaxle connector, and install it to the oil strainer.
7. Install the transaxle connector.
8. Install the control valve body. (See
End Of Sie

TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION

Warning
• When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait until they
are cool before replacing the ATF.
1. Remove the oil pan. (See
2. Disconnect the TFT sensor connector.
3. Remove the TFT sensor.
4. Install a TFT sensor.
5. Connect the TFT sensor connector.
6. Install the oil pan. (See
BODY INSTALLATION.)
7. Carry out the mechanical system test. (See
MECHANICAL SYSTEM
End Of Sie

OIL PRESSURE SWITCH INSPECTION

Caution
• Water or foreign objects entering the connector can cause poor connection or corrosion. Be sure
not to drop water or foreign objects on the connector when disconnecting it.
On-vehicle Inspection (harness inspection)
1. Disconnect the negative battery cable.
2. Remove the under cover.
AUTOMATIC TRANSAXLE
Resistance (kilohm)
236—324
84.3—110
33.5—42.0
14.7—17.9
7.08—8.17
3.61—4.15
1.96—2.24
1.13—1.28
0.87—0.98
K–35 CONTROL VALVE BODY
K–34 CONTROL VALVE BODY
K–35 CONTROL VALVE
K–6
TEST.)
INSTALLATION.)
REMOVAL.)
A6E5614W024
K
A6E561419010W02
A6E5614W025
A6E561421550W01
K–21