Eeprom Initialization - Oki OKIPAGE 12i Maintenance Manual

4.1.4

EEPROM initialization

The corresponding are of the EEPROM is initialized for each event as shown Table 4-1.
EEPROM area
No Event
1
User maintenance
menu reset
2
System maintenance
EEPROM reset
3
Engine maintenance
engine reset
4
Firm revision check
error at power-on
5
Engine ID check
error at power-on
6
Customer setting
7
User information
error
: Represents initialization
Note1) Items of each maintenance menu which are subjects here are listed in the following table.
Note2) Only when the page counter is 500 sheets or less, it is reset to 0.
Talbe 4-1 Items of Each Maintenance Menu Targeted for EEPROM Reset
User maintenance menu area
Resource save
Receiving buffer
Operator panel menu function
enable/disable
X/Y ADJUST
2ND feed destination
designating command
Left alignment based printing shift
Cleaning cycle
Transfer current
(Only Engine ID check error at
power on Event)
40718301TH Rev.6
Talbe 4-1 EEPROM Initial Setting Range
System maintenance menu area
Whether a page counter printing is
added or not to a menu printing
SIDM emulation switch
enable/disable
Note2) Note2)
Engine maintenance menu area
LED head drive time
(excluding during engine reset in engine maintenance)
Adjusting head type
(excluding during engine reset in engine maintenance)
600 × 1200DPI strobe time relative value
(excluding during engine reset in engine maintenance)
Installed LED head identification
(excluding during engine reset in engine maintenance)
Print start position
Paper feed amount from each paper feed tray
Each optional tray motor controlling parameter
Engine test
78 /