Eeprom Initialization - Oki OKIPAGE 14i Maintenance Manual

4.1.4

EEPROM initialization

The corresponding are of the EEPROM is initialized for each event as shown Table 4-1.
No Event
1 User maintenance menu
reset
2 System maintenance EE-
PROM reset
3 Engine maintenance
engine reset
4 Firm revision check error
at power-on
5 Customer setting
6 User information error
: Represents initialization
Note1) Engine ID check error at power on is set at default for all menu items, thus it will not be mentioned here.
Items of each maintenance menu which are subjects here are listed in the following table.
Note2) Only when the page counter is 500 sheets or less, it is reset to 0.
Talbe 4-1 Items of Each Maintenance Menu Targeted for EEPROM Reset
User maintenance menu area
Resource save
Receiving buffer
Operator panel menu function
enable/disable
X/Y ADJUST
2ND feed destination
designating command
Left alignment based printing
shift
Cleaning cycle
Jam recovery Enable/Disable
41356801TH Rev.1
Talbe 4-1 EEPROM Initial Setting Range
EEPROM area
System maintenance menu area
Whether a page counter printing is
added or not to a menu printing
SIDM emulation switch
enable/disable
Engine maintenance menu area
No items subjected to.
All except counters are subjected to reset.
As a common spes.
Note2) Note2)
75 /