1.3
Engine Maintenance Mode
•
The engine maintenance mode is activated when the power is turned ON while keeping the FORM
FEED key and ENTER key pressed down.
•
This mode adopts the menu for function selection.
•
The method for exit from this mode depends on the setting.
•
The engine maintenance mode provides the following functions:
(1) Head Drive Time Setting
•
Sets the drive time of the LED head.
(2) Type
•
Do not change the default setting.
(3) Printing Start Position Setting
•
Sets the printing start position.
(4) Drum Count Total Display
•
Displays on the LCD the total number of drum revolutions of the unit, counted at the engine
block.
(5) Drum Count Display
•
Displays on the LCD the total number of EP drum revolutions counted at the engine block.
(6) Factory Adjustment (for High Capacity Second Paper Feeder/Power Envelope Feeder)
•
Do not change the default settings since these are factory settings and were set at the factory.
(7) Engine Reset
•
All EEPROM areas used by the engine block are reset to factory default values.
•
The following items are excluded:
Menu level-1
Menu level-2
Operator panel menu disable/enable
Page print disable/enable
•
Transition to the operation mode occurs upon completion of resetting.
40718301TH Rev.6
155 /