Broil Element - Viking vdsc530t Service Manual

Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.

Broil Element

The unit uses a dual ribbon element to achieve
the broil function. The broil element has four wires
that are attached at the rear and go to the control
board.
To access Broil Element:
1. Remove oven door (see Door Removal section,
page 59).
2. Place oven rack in second position from top.
3. Remove screws and front broil element
bracket from oven cavity.
Broil Element
Screws
Front Broil Element Bracket
4. Remove broil element from back broil
element bracket and lower broil element
to the oven rack.
5. Pull connectors into the oven cavity.
© 2010 Viking Preferred Service
WARNING
6. Mark and disconnect four connectors from
broil element.
Broil Element
Note: During installation, make sure broil
connectors go back through the oven liner.
7. Reverse procedure for installation.
Connectors
63