User Settings - Viking vdsc530t Service Manual

Diagnostics

User Settings

SET HR MIN
MIN/SEC
AM
PM
COOK
STOP TIMER NO PROBE
COOK TIME ON DELAY
To adjust settings:
1. Press "CLEAR" and hold 2 seconds to activate.
2. Toggle "SELECTOR KNOB" right or left to desired setting.
3. When desired setting is flashing, press "SELECTOR KNOB" to change value.
User Setting Function
˚F or ˚C Select Temperature format. Default is ˚F.
12/24 Hr Select Time format. Default is 12 hr.
Sabbath Mode Default is OFF. Refer to EOC4 Product Specification. In general, any operation that can change
state based on the door opening (lights, fans, etc.) is disabled. If Sabbath Mode is enabled, display
SABBATH.
Brightness Select the brightness from 1-5 with 5=brightest setting. Default is 5.
User Offset
Adjust the Temperature Offset. The default is 0. To select, press the
the display shows 00˚F. Rotate the knob as appropriate, the display will increase or decrease
[example: Warmer +100˚F or Colder -150˚F] in 50˚F [20˚C] increments. The max offset is +/- 300˚F
[+/- 160˚C]. When done, press the
applied to the Self-Clean function.
Showroom Mode Disables heating elements, cooling fan and convection fan motor. Oven lights and all display
functions operate normally.
Exit Final step in User Settings. From this step, the user can either exit the User Settings (press on the
"SELECTOR KNOB"
© 2010 Viking Preferred Service
CLOCK/
PROBE
TIMER
TIME
STOP
SETTINGS SETTINGS
TIME
) or enter the diagnostic mode (see page 32).
OVEN
FUNC
OVEN
TEMP
OFF
CLEAR/ CLEAN/
"SELECTOR KNOB"
"SELECTOR KNOB"
to exit. Any User Offset entered is not
and
30