Offset Temperature Adjust - Viking vdsc530t Service Manual

30" electronic control dual fuel range
Hide thumbs Also See for vdsc530t:
Table of Contents

Advertisement

Diagnostics
Offset Temperature Adjustment
SET
HR
MIN
MIN/SEC
AM
PM
COOK
STOP TIMER NO PROBE
COOK TIME ON DELAY
This function is outside the other User Settings. Under most circumstances, the user should not need to
access the Offset Temperature Adjustment.
To adjust settings:
1. Press "CLEAR/SETTINGS" and hold 2 seconds to activate.
2. Toggle "SELECTOR KNOB" right or left to desired setting.
3. When desired setting is flashing, press and hold "CLEAR/SETTINGS" and "OVEN TEMP" for five seconds
to enter.
4. Toggle left/right to get to desired setting (OFFSET).
5. Press "SELECTOR KNOB" to make value flash; toggle up/down as desired (-30˚F to 30˚F; 5˚F increments)
Press "SELECTOR KNOB" to accept. Value stops flashing.
Note: Temperature Offset entered is not applied to the Self-Clean setting.
Important Note: Make sure that a proper temperature test is performed, using a loaded temp probe,
before adjusting the Offsets. Failure to do so can result in improper oven temperatures. Use Viking
Temperature Probe Kit part # G50012698 for accurate readings (see Bulletin 2005-37P).
If you find that the temperature is off, then proper adjustment to the offset setting is required. Decreasing
the offset will increase the temperature, while increasing the offset will decrease the temperature.
Example: If testing the oven at 350°F you find the average temperature is at 320°F, then you need to adjust
the oven temperature up by 30°F.
Adjusting The Offset
Access the Offset adjust program. The Default will show the following:
Now, depress the "SELECTOR KNOB" and the 0° will begin to flash. Rotate the "SELECTOR KNOB" towards
the left until the following is in the display:
By bringing the offset < you will actually increase the temperature by 30°F. The opposite would be true. If
the temperature is 30°F too high, then you would need to adjust the offset > by 30°F.
© 2010 Viking Preferred Service
CLOCK/
PROBE
TIMER
TIME
STOP
SETTINGS
SETTINGS
TIME
OVEN
FUNC
OVEN
TEMP
OFF
CLEAR/
CLEAN/
31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents