Convection Fan Assembly; Convection Fan Cover; Convection Fan - Viking vdsc530t Service Manual

Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.

Convection Fan Assembly

The convection fan assembly incorporates a heating
element and a two direction fan to move air
through the cavity ensuring even heat distribution.

Convection Fan Cover

To access Convection Fan Cover:
1. Remove left rack support (see Rack Support
section, page 60).
2. Remove screws and fan cover from oven
cavity.
Screw
3. Reverse procedure for installation.
© 2010 Viking Preferred Service
Screws
Fan Cover
WARNING

Convection Fan

To access Convection Fan:
1. Remove convection fan cover (see Convection
Fan Cover section).
2. Remove screws and set convection fan
assembly on oven liner.
Convection
Fan Assembly
3. Disconnect connector and lift convection fan
assembly from oven cavity.
Convection
Fan Assembly
Note: The mounting hole pattern for the
convection fan assembly is NOT symmetrical. Line
up holes before installing.
4. Reverse procedure for installation.
Screws
Connector
61