Hardware Description - NETGEAR WG302 Reference Manual

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302

Hardware Description

The NETGEAR ProSafe Wireless Access Point 802.11g WG302 front and rear hardware
functions are described below.
The WG302 Access Point provides four status LEDs.
Figure 2-1: WG302 front panel
The following table explains the LED indicators:
LED DESCRIPTION
PWR Power Indicator
Off No power. If this LED does not come on with the power adapter and cord correctly
installed, see Chapter 4, Troubleshooting.
On Power is on.
TEST Self Test Indicator
Blink Indicates self test, loading software, or system fault (if continues).
Note: This LED may blink for a minute before going off.
100 Ethernet LAN Speed Indicator
Off Indicates 10 Mbps Ethernet link detected
Green On 100 Mbps Fast Ethernet link detected.
LINK/ACT LAN Ethernet LAN Link Activity Indicator
Off Indicates no Ethernet link detected.
Green On 100 Mbps Fast Ethernet link detected, no activity.
Green Blink Indicates data traffic on the 100Mbps Ethernet LAN.
Amber 0n 10 Mbps Ethernet link detected, no activity.
Amber Blink Indicates data traffic on the 10Mbps Ethernet LAN.
2-6
September 2004
Introduction