Basic Installation And Configuration; Observing Placement And Range Guidelines - NETGEAR WG302 Reference Manual

This chapter describes how to set up your NETGEAR ProSafe Wireless Access Point 802.11g
WG302 for wireless connectivity to your LAN. This basic configuration will enable computers
with 802.11b or 802.11g wireless adapters to do such things as connect to the Internet, or access
printers and files on your LAN.
Indoors, computers can connect over 802.11g wireless networks at ranges
Note:
of several hundred feet or more.
to access your network. It is important to take appropriate steps to secure your network
from unauthorized access. The WG302 Access Point provides highly effective security
features which are covered in detail in
Deploy the security features appropriate to your needs.
You need to prepare these three things before you can establish a connection through your wireless
access point:
• A location for the WG302 that conforms to the
below.
• The wireless access point connected to your LAN through a device such as a hub, switch,
router, or Cable/DSL gateway.
• One or more computers with properly configured 802.11b or 802.11g wireless adapters.

Observing Placement and Range Guidelines

The operating distance or range of your wireless connection can vary significantly based on the
physical placement of the wireless access point. The latency, data throughput performance, and
notebook power consumption of wireless adapters also vary depending on your configuration
choices.

Basic Installation and Configuration

Basic Installation and Configuration
This distance can allow for others outside your area
Chapter 3, "Configuring Your Wireless
September 2004
Observing Placement and Range Guidelines
Chapter 3
Network.
3-1