Table of Contents
Advertisement
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
Note: Output power is automatically adjusted by AutoCell when the Auto RF
Management option is enabled. The default setting is for the AutoCell Auto RF
Management option to be enabled.
Understanding WEP/WPA Security Options
The figure below identifies the various WEP/WPA security options. A full explanation of these
standards is available in
WEP/WPA Settings 11a menu
Figure 3-10: WEP/WPA Settings menus for 11a and 11b/g
The WEP/WPA Settings for 11a and 11b/g are explained as follows:
•
WEP: Enable or Disable the Wired Equivalent Privacy for data encryption.
•
Network Authentication: Specifies the Authentication type used: Open System, Shared
Key, Legacy 802.1x, WPA with Radius, or WPA-PSK. The default is Open System.
If Shared Key is selected, you need to enable WEP and enter at least one shared key.
3-18
Appendix B, "Wireless Networking
202-10078-01
Basics.
WEP/WPA Settings 11b/g menu
Basic Installation and Configuration
Advertisement
Table of Contents
