Table of Contents
Advertisement
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
Default Factory Settings
When you first receive your WAG302, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
"WAG302 front panel" on page
User Name (case sensitive)
Password (case sensitive)
(if DHCP server is unavailable)
11a Network Name (SSID)
11g Network Name (SSID)
Broadcast Network Name (SSID
802.11a Radio Frequency Channel
802.11g Radio Frequency Channel
AutoCell RF Management
AutoCell Enhanced RF Security 'stealth' mode
Restricting connectivity based on MAC Access
Time Zone Adjust for Daylight Saving TIme
Basic Installation and Configuration
2-6.
FEATURE
Operating Mode
Access Point Name
Built-in DHCP client
Built-in DHCP server
IP Configuration
WEP/WPA
Control List
Spanning Tree Protocol
Time Zone
SNMP
Secure Telnet
202-10078-01
FACTORY DEFAULT SETTINGS
admin
password
Access Point
netgearxxxxxx where xxxxxx are the last six
digits of the wireless access point's MAC address
DHCP client disabled
DHCP server disabled
IP Address: 192.168.0.230
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
NETGEAR_11a
NETGEAR_11g
Enabled
52
11
Enabled
Disabled
Disabled
Disabled
Enabled
GMT
Disabled
Enabled but Trap forwarding is disabled
Enabled
3-3
Advertisement
Table of Contents
