Table of Contents
Advertisement
This chapter describes how to set up your WAG302 ProSafe Dual Band Wireless Access Point for
wireless connectivity to your LAN. This basic configuration will enable computers with 802.11b
or 802.11a/g wireless adapters to do such things as connect to the Internet, or access printers and
files on your LAN.
Indoors, computers can connect over
Note:
networks at ranges of several hundred feet or more.
others outside your area to access your network. It is important to take appropriate steps
to secure your network from unauthorized access. The WAG302 Access Point provides
highly effective security features which are covered in detail in
WPA Security Options" on page
needs.
You need to prepare these three things before you can establish a connection through your wireless
access point:
•
A location for the WAG302 that conforms to the
below.
•
The wireless access point connected to your LAN through a device such as a hub, switch,
router, or Cable/DSL gateway.
•
One or more computers with properly configured 802.11b or 802.11a/g wireless adapters.
Observing Placement and Range Guidelines
The operating distance or range of your wireless connection can vary significantly based on the
physical placement of the wireless access point. The latency, data throughput performance, and
notebook power consumption of wireless adapters also vary depending on your configuration
choices.
Basic Installation and Configuration
Basic Installation and Configuration
3-18. Deploy the security features appropriate to your
202-10078-01
802.11b or 802.11a/g
This distance can allow for
"Understanding WEP/
Observing Placement and Range Guidelines
Chapter 3
wireless
3-1
Advertisement
Table of Contents
