Printing Problems - Panasonic UB-5838C Service Manual

5.2.

Printing Problems

Phenomenon
Printing function does not
operate.
Defects in the printed image
Panaboard test pattern cannot
be printed out at all.
Possible Cause
Panaboard (This unit) does not recognize
its being connected to a printer.
The illustration of USB Flash Memory
Device or SD Memory Card is displayed
at the center of LCD.
The amount of the printer ink is enough to
print out.
The printer has some problems.
1. Check that the standby state is as follows when
restarting this unit.
2. Check whether a printer is properly connected to
this unit (Panaboard) or is supplied with power.
3. Check whether a printer is available for this
Panaboard.
→
For information regarding available printers,
refer to the following site:
http://panasonic.co.jp/pcc/products/en/eboard/
ub-5838c_info.htm
1. Remove the USB Flash Memory Device or SD
Memory Card from the unit (Panaboard), and
then check whether that removal changes the
illustration to the printer's.
1. Check whether the phenomenon is reproduced
with the Panaboard's printing test as follows.
(Procedures for Panaboard's printing test)
(1) Push the Set-up Key.
(2) Push the Set-up Key repeatedly to select
the following item (Item: Testing the Printer)
(3) Push the Advance Key to perform the test
printing.
(4) Push the Mode Key to return the standby
mode.
2. Replace the ink cartridge according to the
operation instructions for the printer.
1. Maintain the printer according to the operation
instructions for the printer.
36
Check Point