Panasonic UB-5838C Service Manual page 34

Error Code
Display Code Name
U307035 USB Flash
Memory Device
Write-protection
U307037 FAT 16 Format
Error
U307144 USB Flash
Memory Device
Write Error
U307160 Same as "U307014"
U307161 Same as "U307001"
U308001 Un-supported
Printer Connection
U308002 Printer Paper
Empty
U308003 Printer Error
U308004
U314161 Un-supported
Printer Connection
U314224 Printer Error
U314225 Printer Ink Empty The ink in the printer is empty. 1. Replace the ink cartridge according to the Operation
U314226 Printer Paper
Empty
U314227 Printer Paper Jam A paper jam in the printer
U314228 Printer Working
U314229 Printer
U314231 Communication
Error
U402002 No Output Device There is no device to output.
U403012 Screen Feed Error 1. Screen Film did not reach
U403021 Same as "U103021"
U403022 Same as "U103022"
U403023 Same as "U103023"
U403024 Same as "U103024"
U403025 Same as "U103025"
U406010 SD Memory Card
Full
U406035 Same as "U306014"
Possible Cause
The USB Flash Memory
Device has been set to
write-protect.
USB Flash Memory Device
with a un-supported FAT16
Format is set to this unit.
USB Flash Memory Device
Write Error occurred.
A un-supported printer for this
unit is connected.
Paper set in the printer is
empty.
There is a Printer error.
A un-supported printer for this
unit is connected.
The printer does not work
correctly.
Paper set in the printer is
empty.
occurred.
The printer is working now.
During printing, an error of the
communication between the
printer and this unit occurred.
its home position.
2. The Home Marker is peeled
off.
3. Home Sensor did not work
correctly.
The available space in the SD
Memory Card became full
while scanning.
1. Cancel the write-protection.
1. Re-format the USB Flash Memory Device with the FAT32
Format.
1. Check whether the USB Flash Memory Device can be
correctly written with a PC.
1. Connect a printer that meets the requirements of this unit.
1. Set paper in the printer according to the Operation
Instructions for the printer.
1. Fix the printer error according to the printer manual.
1. Connect a printer that meets the requirements of this unit.
1. Restart the printer and then check its operations.
Instructions for the printer.
1. Set paper in the printer according to the Operation
Instructions for the printer.
1. Remove the jamming paper in the printer.
1. After confirming that the printer changes to "Ready",
perform the copy function for the printer.
1. After confirming the connection between the printer and
Panaboard, restart the printer and then check its operations.
1. Set a USB Flash Memory Device, a SD Memory Card,
a printer, or a PC that meets the requirements of
this unit.
1. Check whether the Home Marker is attached on the Screen
Film.
2. Check the connection between CN4 (CONTROL Board)
and CN800 (MOTOR DRIVE Board).
3. Check the connection between CN802 (MOTOR DRIVE
Board) and Motor.
4. Check the soldering conditions of IC800 and Q800 on the
MOTOR DRIVE Board.
5. Check the soldering conditions of IC9 and R280 to R283
on the CONTROL Board.
6. Replace faulty parts, Motor, MOTOR DRIVE Board, or
CONTROL Board.
Make the available space with a PC and then scan again.
34
Check Point