Avaya BCM50 Hardware Installation Manual page 51

12. Remove the 4 hard drive screws from the hard drive bracket. Remove
the hard drive.
13. Remove the hard disk and power cable from the connector.
14. Lift the hard disk off the hard disk bracket and set it on a flat, clean,
static-free surface.
15. Place the new hard disk in the hard disk bracket. Use the four hard disk
bracket screws to secure the hard disk to the bracket.
16. Set the hard disk and bracket in the main unit. Make sure that the hard
disk cable and power cable are routed properly. Route the power cable
under the bracket and loop the hard disk cable.
17. Press down lightly on the top of the hard disk to ensure that the hard
disk bracket is seated properly.
NN40011-002 Issue 1.2 BCM50 Rls 6.0
BCM50 Hardware & Installation
51